thanks a bunch GOOCH

 

Tried to find you torque specs in manual, but seems they are not offered up. Searched the forum and found this entry from 2R (current/former member)
----

"ok in the manual where it tells you to install the springs & bolts for clutch page 7-8, it doesn't give specific info for torque on the 5 clutch spring bolts,it simply says tighten bolts & in a criss cross pattern ..etc....now I rememebr this ..
I used the standard torque values for hardware at front of the manual ..
1st let me check .. are these the 10 mm head & 6 mm threads ? correct ?
but honestly ..now I dont remember which torque I used .....looking at the chart ..I would not go over 5-6 ftlbs tho ....most smaller hardware seems to be in that range ...the thing is they are going into an aluminum cast ..so keep that in mind

my advice is tighten them down in a star pattern a few turns at a time & move to the next bolt ..go around a few times til they are snug .,try to feel how the springs are evenly pulled down .but not over tight..the springs will bolts so they can not back out etc."

 

X2...good advice, nice posts GOOCH with all the information for the OP . Carlos