Hi guys. I am trying to get all my cases and bearings and seals ready to put my bottom end back together on my 250r.
My problem I have is the top bolt that goes through the top of the case saver and into the cases it is the 6by 100 bolt well it is broke there is a 1/4 inch part that I can grab with players but it I'd broke where it thread into the center case half.
I have heated up the area not to hot because it is aluminum but I have heated the are sprayed with pb plaster let it sit for a day and did this proces again and I can not get it to even spin out a tuch. Any ideas would be great.
My problem I have is the top bolt that goes through the top of the case saver and into the cases it is the 6by 100 bolt well it is broke there is a 1/4 inch part that I can grab with players but it I'd broke where it thread into the center case half.
I have heated up the area not to hot because it is aluminum but I have heated the are sprayed with pb plaster let it sit for a day and did this proces again and I can not get it to even spin out a tuch. Any ideas would be great.
