Honda TRX250R Forums banner

Status
Not open for further replies.
21 - 28 of 28 Posts

·
Registered
Joined
·
4,143 Posts
LED has all the gears except for 1st on the main shaft, its built onto the stock shaft.
 

·
Registered
Joined
·
2,924 Posts
well considering who started the thread and what they were trying to achieve i'd say well done to every one else
 

·
Registered
Joined
·
313 Posts
conclusion don’t need aftermarket gears. oem works good. buy bilet gears u want to spend xtra $. how many broke oem gears? i dont know any locally. any posters broke oem? dont think any.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
116 Posts
I have seen a few busted stock tranny's. I have both a Yukon trans and a cryoed one. Both are holding up. Pete at hybrid had mine cryoed.
 

·
Registered
Joined
·
12,861 Posts
How often have OEM gears failed... ?
Usually you see pitting.
When I ever get to my trans rebuild, I would like to remove 5-6th, I dont use them. Is the process a PITA ?
To be clear, and dispel the fake posters who think they know it all; BDT stocks and sells the very same Billet Gear sets mentioned & sold by two other suppliers listed above...all three of us (BDT included) purchase the gear sets from the same single source. Therefore I have no skin in not wanting to sell Billet gears, in reality if you want to spend $625 or $750 or for the combined set $1375...BDT has them in stock waiting for you.

Very few if any OEM gears break or fail, specially on engines <370CC. However; even on BB engines well over 500CC...Pumas at 431CC & Saber's at >500CC have been running OEM gears for years built by numerous builders with little or no transmission failures. The advent of Billet Gears started with Yukon's years ago, as soon as the Yukon supply ran out, a couple of other manufactures stepped up with aftermarket Billet Gears.

The Billet gear sets are very nice, good looking gears, well made....the question is are they really needed? The answer IMO is a resounding NO. Good OEM CryO'd gears sets are every bit as good, at BDT we internally Magnaflux all OEM gear Sets and send out for CryO...I have not seen an OEM CryO'd BDT gear set failure in years.

Carlos
 

·
Registered
Joined
·
2,924 Posts
what fake posters ? others giving there opinions that's all. facts other enthusiests have here own experiences and are giving free information. you are not the only sorce of information so you don't have to push others into the ground.
thank you
 

·
Registered
Joined
·
313 Posts
start with me. all u ever have to say is bad towards me. or u saying my experiences dont matter.


Sent from my iPhone using Tapatalk
 
21 - 28 of 28 Posts
Status
Not open for further replies.
Top