Honda TRX250R Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
929 Posts
you may need to spread the pinch point w a punch or screw driver. Take the allen bolts out.
 

·
Registered
Joined
·
226 Posts
Cant figure out how to tighten or loosen the chain. Does not look like the one in the manual or others I've seen on the internet
that looks like a lonestar billet carrier.i have one. like the gentleman before said loosen up the pinch bolts and you see the holes on the carrier before your sprocket. i have a tool that came with mine, however you can insert an allen key or small rod the same diameter as the hole and the carrier will rotate either from or backwards. this rotation is how you loosen or tighten your chain.any questions im here its easy sir just let me know if you have any problems take care
 

·
Registered
Joined
·
13,059 Posts
Cant figure out how to tighten or loosen the chain. Does not look like the one in the manual or others I've seen on the internet
Good advice already posted by cmorris & trailburner....I will add that sometimes they get stuck in the swingarm; dirt, sand, water gets in and corrodes the BC to the SA in place. Take PB Blaster or any release agent and spray & let it soak for a few days. Wiggle with wrench or rod provided with BC back and forth to loosen up.

Carlos
 

·
Registered
Joined
·
929 Posts
And tap with a med hammer upward to loosen, just did mine 5 mins ago to verify. Minimum 4 to 5 in pin, I used 10mm bolt, I may have drill to size years ago.
 
1 - 8 of 8 Posts
Top