[meat]

...

 

[C-Leigh Racing]

All you got to do is measure it. Inside bore DIA, outside DIA & width in MMs.

It would be highly unlikely RPM had those bearings custom made, but, then again at 105.00 a set, looks like you would be paying for the special order.
Heres what I'm wondering though, kinda scratching my head, the whole idea behind a taper bearing is it can stand more abuse & last a kazilloin years,

 

[C-Leigh Racing]

When I took off the hubs, the inner bearing was stuck really really good on the spindle :angry: . The puller I had wouldnt grab the bearing because the seal was still behind the bearing and there was no where to grab the bearing and the seal

Yeah I see what you mean, you know though, I guess $105 aint that bad for both sides, aint but 13.12 for each piece if it all pieces cost the same each.
Neil

 

[2R's]

try checking here


http://www.thebigbearingstore.com/servlet/...ller%20Bearings

 

[mstohner]

you proably can get them thru napa or a different brand in that size.