if you raise up the rear of the quad is the axle free to rotate ? brakes stuck? carrier bearing locked up? broken sproket tooth stuck in chain ? or is it a inside the trans mission issue ? clutch adjusted or fried ?
You can kick it and start it so assume your kick start shaft, idler, and clutch gear are fine. Can you feel it firmly going into each gear? You have either shift fork problems (split cases) or a bad clutch. Your clutch probably isn't it as it would at least try to grab. If the basket was broken you'd hear it. pull the clutch cover and look in there. If all looks fine it's a fork at best. Worst is another story.
well least the quad wont get dirty or wrecked LOL j/k
"It does'nt even grab"
sounds like ^ this is a description of clutch not working so ..
start at clutch cable adjusted right ,( assuming all needed pcs are intact & ok /not locked up etc chain , sprockets carrier brake etc )..then of all ok move on to remove c cover check if all pcs are intact & tight etc .. if so move on to other stuff like rebuild motor !
...also consult MANUAL for this problem could be an EYE opener ..
hi mate, your problem could be none of the above and a really simply fix, remove the the clutch side casing and look in the bottom left corner
while lifting the shifter up and down and you might see that it's not attatched to the arm, you'll see when your looking at the rod and lifting the shifter.
pull the shifter out slightly and get it into the piece were it sits in like a elongated hole, definately worth a look.
also make sure you don't pull the shifter back out while pushing the clutch side casing on because the end of the rod sits up to the casing to stop it coming of that shifter arm.
If the clutch is adjusted correctly, and your clutch lever, rod and all your plates, fibers, springs and clutch basket are good, then it is likely the 'hat' type washer on the shift lever arm that engages the shift star is out of location, or the spring & lever on the shift star/drum is not in place or broken, or you can have bent shift fork(s), or an improperly assembled transmission.
hey. got the same problem whit a e-ton viper st 50. it starts and go but when i set it in gear it make some noises at the beggining. but now it starts and when i change gear on it, it won`t change the lamp for that gear is flassing. some times it makes it in to that gear but get turned off and can`t start it before 5min or more. clutch is working and we have looked at the chain nothing destroyed there.
Ok I’ve read it all, googled it all, searched. I have found good info and spoken to the best. I’m so done with my TRX ign. I have new harness and motor. Sometimes it’s starts, other times sounds like kill switch is on. Sometimes it runs good, next won’t start. So I tap on cdi works...and so on...
hi all due to my exhaust port being quite large and high i lowered my cylinder 0.5mm approx to try gain some bottom end power this means that my piston sits just above the transfer ports at bdc and also the bottom of the exhaust,will this make it run worse and undo any the gain im trying to...
I've got an 87 250r with a ESR 330 PV and an pkw 38mm carb. I've been noticing that at the high end, I'm getting what seems to be a rev limiter. Like the spark cant keep up or something. I've changed the CDI box and cleaned the air filter to make sure the engine can get its air.
So I just picked up a TRX250r last night, a pretty good deal for what it is. I was with my brother and I told him to test it before we bought it, he kept saying no it’s fine he doesn’t want to get the cops called on us so we made sure it started and everything, turned on quick, I could feel the...