Honda TRX250R Forums banner

Parting out Lonestar 250R

1463 Views 10 Replies 10 Participants Last post by  TheNewn

Lrd 310 power valve kit. 86 case with spacer for lond rod. 38mm kehlin(spelling)carb. Boyseen rad valve with spacer. Has billet exhaust flange,case saver.

Motor is fresh with lots of compression. Can provide LRD serial # if you would like

Also have LRD ajustibale pipe, FMF fatty pipe, and FMF silencer. All in good condition.

Don't know much about 2-strokes. I brought a 250R Cheap with a lot of good stuff on it to part out.

Lonestar frame 03

Lonestar swingarm, i belive -2

Lonestar extended axle +2-+4
Lonestar carrier
Lonestar antifade nut
Will sell together or individual.

Lonestar +2 stem

Laegers +2+1 A-arms(reg travel)

TCS triple rate shocks in front(reg travel)W/ reomte rezzys

TCS double rate in rear W/remote rezzy
Would like to seel as set.

Also have a good set of plastics with graphics and set cover and after market OMF seat latch.

And all other factory parts that you might need(brakes,Throttle,hubs,master cylinders, ETC)

Any thing you might need ask i might have. Any questions please PM, Post, or E-mail me at [email protected]
Thanks, Steve
See less See more
1 - 1 of 11 Posts
what are you looking to get for the lrd adjustable?
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.