Honda TRX250R Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
491 Posts
Discussion Starter #1
Has anybody ever used the OEM basket with a pro-x 310 cylinders without problems of breaking ?
 

·
Registered
Joined
·
222 Posts
I didn't have any breaking problems, they do get grooved quick. My 86 motor(was a crate motor, raced for a short time) had a stock basket, its grooved bad. I have a 85 motor that has a good amouunt of hours on a stock basket, it has some grooves, nothing bad. Both motors had/have 310 pv's.
 

·
Registered
Joined
·
190 Posts
deathman is correct. for the time being your OEM will be ok but plan on getting an aftermarket in the future. i'd reccomend a P/E basket from MotoSport. its a good basket for the money. B)
 

·
Registered
Joined
·
2,042 Posts
I ran an original stock basket on my 330 for about two years. They said it had some grooves in it when the 330 kit was put on, but it could go a little longer. I took a chance and it held up okay. I'm usually not that hard on clutches. If you are real hard on it, then you might think about changing it.
 
1 - 4 of 4 Posts
Top