Honda TRX250R Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 86 trx 250R that was running fine. I changed fluids oil & coolant replaced fuel lines I detailed the engine & washed it , I assembled my quad again now it’s super smoky (white) & boggy I checked my cdi seems to be working fine I replaced my ignition coil no change I cleaned my carb checked jets everything seems fine … any other suggestions?
 

·
Registered
Joined
·
51 Posts
Check the stator behind the flywheel. Water has a nasty way of penetrating past the old wore out grommet on the wire harness seal. When you say detailed the engine... Did you use pressurized water? I only clean my engine by hand and I use silicone sealant around the wire grommets. Hope this helps
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Check the stator behind the flywheel. Water has a nasty way of penetrating past the old wore out grommet on the wire harness seal. When you say detailed the engine... Did you use pressurized water? I only clean my engine by hand and I use silicone sealant around the wire grommets. Hope this helps
Thanks I used light degreaser & hosed it down .
 
1 - 3 of 3 Posts
Top