Honda TRX250R Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1 (Edited)
I just got a new 310 kit from Eddie and tried to put it on the studs but it seems I have one stud that is like 1/16in to far inside. Or the jug hole is miss-aligned. could my stud be bent or should I just force it on? Do I try to bend it out or just replace the stud?
 

·
Registered
Joined
·
21 Posts
Discussion Starter #2
Well it was a bent head stud, not sure how it happened but I will replace it. Do you add loc-tite on the head studs?
 

·
Registered
Joined
·
52 Posts
DON'T MODIFY ANYTHING...it could be a bad casting...measure the distance between all of the studs and see what the most common measurement is, then compare it to the one on the weird stud...
 
1 - 5 of 5 Posts
Top