Honda TRX250R Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
84 Posts
Discussion Starter #1
that I caused. When riding wide open in 4th the other day it would bog and what I think was running out of gas. I would roll to a stop, kick it and start right back up and run until I did the same thing. So I thought the floats weren't letting the bowl fill all the way up so I pulled the carb apart and made a slight.....ever so slight bend in the float, I believe up. I was late at night, I should have waited but I just got jets and new needle. So I didnt test it until the next day, I turned the gas on, didnt check and dumped about a gallon of race gas on my garage floor. So Im thinking I went to far with the adjustment bend? Which direction should I go to correct this? I just want to make sure I dont do it wrong again, tired of pulling the carb in and out. Does anyone have a link on how to measure the float adjustment?

I appreciate any help.
 

·
Registered
Joined
·
877 Posts
I think height is 16.5mm with carb upside down(so basically where bowl sits) to bottom float which at top right now
want to kinda hold carb sideways so float floats not compressing float needle
i hope helped and didn’t confuse u more
 

·
Registered
Joined
·
84 Posts
Discussion Starter #3
Thank you, thats what I was looking for, I had read it somewhere on here once before and couldn't find it. Going to give it a try, thanks.
I think height is 16.5mm with carb upside down(so basically where bowl sits) to bottom float which at top right now
want to kinda hold carb sideways so float floats not compressing float needle
i hope helped and didn’t confuse u more
 
1 - 4 of 4 Posts
Top