Honda TRX250R Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
Hey....im just wondering if anyone knows the dimensions of the o-rings i need for my ESR exhaust flange. Also....can i find the o-rings at fastenal? Thanks
 

·
Registered
Joined
·
349 Posts
good question, i gave up my search for the o rings and just plastered it with hi temp gasket sealer. Holds well.
 

·
Registered
Joined
·
719 Posts
Not sure if you're just looking for an alternate place to get them, but esr stocks'em. Last time i needed some, i ordered 25.
If you don't mind me asking how much were they?

Not trying to steal the thread here, but has anyone bought new high temp o-rings for their ESR silencers? If so, is there an alternate place to get them besides ESR? How much are they from ESR? Thanks in advance!!
 

·
Registered
Joined
·
75 Posts
Discussion Starter · #5 ·
If you don't mind me asking how much were they?

Not trying to steal the thread here, but has anyone bought new high temp o-rings for their ESR silencers? If so, is there an alternate place to get them besides ESR? How much are they from ESR? Thanks in advance!!

No problem...i have just been lookin all over for these and cant find them at all. I think im gonna goto fastenal and see if they have some high temp o-rings. Since im on the east coast, shipping would be crazy.... even if i ordered 10 of them from ESR.
 

·
Registered
Joined
·
399 Posts
I get mine at Napa.Never really saw the size.I had an old original one and matched it up.I have also took the flange with me once and found some that fit.i believe the material is viton.Even with new o rings,I always use a little high temp silicone when installing the pipe.
 

·
Registered
Joined
·
399 Posts
BTW,I will probaly be ordering a pipe from ESR tomorrow and probaly some orings will Im at it.Ill get some extras if any of you guys need them,ill have them without the shipping.I can just throw them in a padded envelope or small box and mail them.
 

·
Registered
Joined
·
46 Posts
FMF sells a spring and o-ring kit for a CR and the o-rings fit the ESR flange and the springs fit my LRD pipe(dont know about other pipes), but i picked one up at a local bike shop shop for 6 or 7 bucks.
 

·
Registered
Joined
·
503 Posts
I get mine at Napa.Never really saw the size.I had an old original one and matched it up.I have also took the flange with me once and found some that fit.i believe the material is viton.Even with new o rings,I always use a little high temp silicone when installing the pipe.
How did the Napa orings hold up to the heat? Can you measure one of the ESR
orings for me? Thanks.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top