Honda TRX250R Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
The motor is an 86 with a spacer plate and 87+ rod. Bored .080 over, cr head gasket. Just put a fresh set off rings in it. Just put a Tusk clutch in it at the first of the year. Has lots of compression, I ran 100+ octane threw it with Klotz Super techni-plate. There is a spot where there is jb weld on the left case from the swinger rubbing it. Does not leak at all been like that for over a year know and no problems. Any question just let me know. Also I can get a shipping quote to your zip in a about day. MAKE OFFER!!!! NEEDS TO GO. ALSO LOOKING FOR A BANSHEE MOTOR OR BOTTOM END, YFZ LT FRONT SHOCKS AND REAR SHOCK, OR CR500 MOTOR FOR TRADE OR SOME KIND OF DEAL.

$600 Shipped obo



 
1 - 4 of 4 Posts
Top