cracked a part in my pwk!!

[pantera1975]

I was cleaning my carb a 38 mm pwk and I took this part off put it back on and the orig must have popped out and then cracked the casting. Can I get this part separate? I hope so I've only run like 10 gallons of gas thru it.

[danhung11]

Try Sudco...

http://www.sudco.com/Diagrams123/exppwk.gif

[pantera1975]

I looked there it says on the bottom middle DO NOT REMOVE PARTS NOT SHOWN! I guess I should not have. Lesson learned.

[mx250r91]

Yes that is not supposed to be removed for normal cleaning and maintenance, that's why it has security torx screws holding it in!

[pantera1975]

Its just a diff torx bit to mqe alot of things i work on at work have them. I think it can b welded plus its only cracked around the mounting hole.

[deadly]

Actually I had a similar experience years ago with a Trenga racing carb on my daughters blaster. I called Sudco and they had parts victims laying around and were able to supply me with the part/s I needed. Call them! The worst answer you can get is no.

[acecarlos]

Welding Sudco cast carbs is almost impossible, terrible results...we will get a replacement "tower" on the way to you Jeff today.

Carlos.

[danhung11]

Welding Sudco cast carbs is almost impossible, terrible results...we will get a replacement "tower" on the way to you Jeff today.

Carlos.

Very cool Carlos!